Pro Tools 7.4cs3 Updates for all 7.4 Systems
Pro Tools 7.4cs3 updates for all Pro Tools 7.4 systems are vailable for download from the Pro Tools CS Updates page:
www.digidesign.com/support/csupdates And related support sections for Pro Tools 7.4 software and hardware. Previous installation of Pro Tools 7.4 required to use these updates:
Pro Tools HD 7.4cs3 for Mac & Windows Fixed: Surround Pan Automation is not Updating Properly in Loop Playback (Item # 85802) The pan positions are correct on the first play of the selection, but can be incorrect on subsequent plays Fixed: Playback of Surround Panning automation gets "stuck" (Item #100847) This would only occur when writing automation with a selection highlighted while in Loop Playback mode Fixed: Trim Values Could Be Accidentally Written To The Entire Session (Item #100795) Steps to reproduce: - A fader position in Latch/Trim or Touch Trim could be accidentally bumped while the transport was stopped. - Subsequently leaving Trim mode, or manually coalescing trims would then write that bumped value to the entire track Fixed: Pro Tools Automation Thinning Could Sometimes Remove Non-Redundant Breakpoints (Item #100794) The thinning algorithm could mistakenly classify a breakpoint as redundant Fixed: Certain Third Party Products Could Cause Pro Tools to crash (Item #100661) Celemony Melodyne and AudioEase Snapper would cause a crash with tick-based regions (introduced in Pro Tools 7.4) Fixed: Mojo - PAL QuickTime or MXF Movies Could Stutter or Display in Black and White (Item #101047) This resulted from Mojo getting "stuck" in NTSC mode even when Pro Tools was set to PAL Mac Only: Fixed: Scrubbing Avid Video on the Computer Monitor Would Resize the Picture (Item #100657) Pro Tools LE 7.4cs3 for Mac & Windows Fixed: When Monitoring All Inputs on 003 Factory, Random Pops and Clicks Could Occur on Inputs 4-8 (Item #101084) Although this is not likely to occur on 003 Rack, this update is recommended for both 003 Factory (console) and 003 Rack Fixed: Pro Tools Automation Thinning Could Sometimes Remove Non-Redundant Breakpoints (Item #100794) The thinning algorithm could mistakenly classify a breakpoint as redundant Fixed: Certain Third Party Products Could Cause Pro Tools to crash (Item #100661) Celemony Melodyne and AudioEase Snapper would cause a crash with tick-based regions (introduced in Pro Tools 7.4) Fixed: Mojo - PAL QuickTime or MXF Movies Could Stutter or Display in Black and White (Item #101047) This resulted from Mojo getting "stuck" in NTSC mode even when Pro Tools was set to PAL Mac Only: Fixed: Scrubbing Avid Video on the Computer Monitor Would Resize the Picture (Item #100657) Pro Tools M-Powered 7.4cs3 for Mac & Windows Fixed: Pro Tools Automation Thinning Could Sometimes Remove Non-Redundant Breakpoints (Item #100794) The thinning algorithm could mistakenly classify a breakpoint as redundant Fixed: Certain Third Party Products Could Cause Pro Tools to crash (Item #100661) Celemony Melodyne and AudioEase Snapper would cause a crash with tick-based regions (introduced in Pro Tools 7.4) |
All times are GMT -7. The time now is 03:03 PM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com