Tracks not showing up in D control
Just started using it, and for some reason the tracks aren't showing up on the fader section. 2 channels say D- control on the unit.
I'm reading the guide now, but I'm not sure where to start. We are using PT hd 2011 on a mac system OS X 10.10.5 Cheers. |
Re: Tracks not showing up in D control
Did you enable the console in the periphials section of Pro Tools?
|
Re: Tracks not showing up in D control
If it says D-Control on the two channel it means the board is offline mode. First, you must have a main console section of the D-Control to use the D-Control control surface. The Fader units cannot be used alone even though they show up in Pro Tools. Secondly, it only shows D-Control on the fader and main units when you are NOT in an active session in Pro Tools because (of course) this is a control service only for Pro Tools even though you can use the monitoring section to hear any sounds input into the XMON.
I hope this helps. Feel free to PM me if you need any additional help. |
All times are GMT -7. The time now is 07:22 PM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com