2018.7 Automation choppy with Eucon controller
 

So after updating to 2018.7 my automation has become really choppy when using my Artist Control, tried a different controller and same result. However, if I do an automation move with my mouse it is smooth. Attached is a screenshot explaining what is happening. On the left is the automation created while using the fader on the Artist mix controller, on the right is the automation created while using the mouse to do the move. Big difference.

Attachment 10830

Re: 2018.7 Automation choppy with Eucon controller
 

Same here on an Artist Mix, both Eucon 3.7 and 18.3 (currently latest version). Firmware is up to date. Turning off thinning doesn't help.

PT Ultimate 2018.7 Mac

Re: 2018.7 Automation choppy with Eucon controller
 

I'll look into this but please post EUCON in the Control Surfaces forums as I don't usually have time to look in PT ones and might miss things.

Re: 2018.7 Automation choppy with Eucon controller
 

Logged as GWSW-11519, but still waiting for a fix.

Cant his thread be moved to the Artist forum?

Re: 2018.7 Automation choppy with Eucon controller
 

Moved :-)

Re: 2018.7 Automation choppy with Eucon controller
 

Any luck so far Eddie?

Re: 2018.7 Automation choppy with Eucon controller
 

Sorry we are still looking into this.

Re: 2018.7 Automation choppy with Eucon controller
 

I have the same problem.
Mine is looking even choppier than your picture.
Sometimes getting triangular chops when leaving go of the fader.

Re: 2018.7 Automation choppy with Eucon controller
 

What is the status of this issue nowadays?

For me the Eucon automation has improved a bit over time but has never been like it was before PT 2018.7.

Is this Artist only or are the S1/S3 also affected?

Re: 2018.7 Automation choppy with Eucon controller
 

This should be much improved if on the latest versions of PT and EUCON