Protools 12 and Apogee One USB 1.1
Hi,
I'm trying to record using an Apogee One into a Macboo pro 2019. It's powering on and being detected when connected to my Macbook but I'm not able to select as Input in a session as it ghosted grey. I am able top playback audio in the PT session but I'm not able to select record. I have Shure SM 58 hooked up. The Apogee One is is selectable as an audio device when opening another DAW like Garageband or Logic. I have followed all the procedures but I still can not see apogee ONE as an input device in protools. Is there a compatability issue. What do I need to do? Iv'e followed the procedures on this link. I have sufficient ram and harddrive and I'm on a macbook pro 16. https://knowledgebase.apogeedigital....lletin/macos-1 Any help would be much appreciated Thank you |
Re: Protools 12 and Apogee One USB 1.1
Most likely it's not selected as the playback engine Setup>Playback Engine.
If it is then go to Setup>IO>{input,output,bus} and on each page select and delete all paths and press the Default Button. And try reselecting the input IO on the track if needed. |
All times are GMT -7. The time now is 02:30 PM. |
Powered by: vBulletin, Copyright ©2000 - 2008, Jelsoft Enterprises Limited. Forum Hosted By: URLJet.com