Tregtntent
06-27-2016, 03:37 PM
HOPEFULLY SOMEONE WILL READ THIS BECAUSE I NEED HELP TOO!!
I'm working with a control 24 and PT10 3.7.9. My message is saying that there is a Ethernet error. So it never gets to scan for the control 24. I recently upgraded my CPU to an i7 6 core MONSTER!! It came installed with Windows 10 Home Ed, and tweaked for running pro audio. Of course with the old CPU, running Windows 7 it worked like a charm. The steps I've taken so far is installing the Diginet file so it shows up under the ethernet protocol, also I've tried changing the compatibility mode under the PT shortcut to Win 7, with no luck, and lastly, I bought a network card and installed it, but was a waste of a few bucks. Any ideas of what it could be? I haven't seen any information about the Control 24 working with a PT system running Win 10. I'm stumped at this point.
Thanks for any suggestions
TG
I'm working with a control 24 and PT10 3.7.9. My message is saying that there is a Ethernet error. So it never gets to scan for the control 24. I recently upgraded my CPU to an i7 6 core MONSTER!! It came installed with Windows 10 Home Ed, and tweaked for running pro audio. Of course with the old CPU, running Windows 7 it worked like a charm. The steps I've taken so far is installing the Diginet file so it shows up under the ethernet protocol, also I've tried changing the compatibility mode under the PT shortcut to Win 7, with no luck, and lastly, I bought a network card and installed it, but was a waste of a few bucks. Any ideas of what it could be? I haven't seen any information about the Control 24 working with a PT system running Win 10. I'm stumped at this point.
Thanks for any suggestions
TG