missing 002R inputs

[mjm333]

I upgraded from PT8.0.4 to PT9 last night and everything went swimmingly, save for one curious bit.

In new PT9 sessions, my 002R now only shows available inputs 1 and 2, and two SPDIF inputs. Four total inputs. Gone are all the rest of the inputs that used to be available to me (channels 3,4,5,6, etc).

Another clue- I opened a session that was created in PT8, and those tracks DO show all the old inputs available.

What am I missing?

Thanks!

Mac 2x2.26 Quad Intel / OS 10.6.4 / 12GB RAM / PT9 / 002R / internal 1TB system drive / internal 1TB audio drive

[getz76]

You need to change your I/O setup.

See page 83 of the manual.

[mjm333]

That thought did occur to me this morning- thanks getz76.

I sort of talked myself out of it since I don't recall ever doing that before, going back to my digi001 and PT6. And I haven't seen this issue on this forum.

Either way, I very much appreciate your direction. I'll look it up! Anything tricky in that area, seeing as I've never played with setting up inputs before?

[getz76]

Nothing tricky at all. Just go to each tab and hit "Default" and you should be fine.

[mjm333]

awesome. thank you sir!

[getz76]

Make sure you interface is selected as the 002R.